HF-8811 電線加熱變形試驗機
PARALLEL PLATE PLASTOMETER
JIS-C-3005
試料本機溫度中，加熱 30 分鐘后，夾在本機平行板間，加規定之荷重，于同溫下再經 30 分鐘，然后以加熱前后之厚度差，除以加熱前厚度，以百分比為單位，即為變形率。
This machine is used for the heat deformation test of power cords。Put specimen into test chamber of this machine under a certain temperature for 30 minutes，then clamp specimen between two parallel plates，the upper plates being subject to a constant load under the same temperature for 30 minutes。Afterwards，the differential thickness before / after heating is
divided by the thickness before heating and multiplied by % for being unit，that is deformation。
|
試料數量 Specimen volume |
3 組 ( sets ) |
|
溫度控制器 Temp. controller |
PID 數位設定 PID dial setting |
|
溫度范圍 Temperature range |
室溫 Room temp. ~ 200℃ |
|
砝碼 Load |
50，100，200，500，1000g |
|
厚度計 Micro-gauge |
0.01 ~ 10mm |
|
電源 Power |
AC220V / 50Hz |
