Oxford Dial Indicating Bore Gauges 59mm (2 3/16") Dial Diameter

Suitable for rapid, accurate measurement of size, concentricity, wear, taper, etc., in a wide range of bores. For workshop and inspection use. All models have one fixed and one moving anvil and a self-adjusting centre shoe. A "Datum Point" can be set by using a setting ring of a known diameter or a micrometer. "Zero" the gauge to this datum point by rotating the bezel to align "zero"with the indicator. To check a bore is within tolerance, the limit hands can be fixed as required. All anvils are spring loaded to expand into the bore. For accurate reading ensure the stem of the gauge is parallel to the axis of the bore. This can be checked by "rocking" the gauge back and forth until the allest diameter is found. All models have inter-changeable anvils to cover a range of bore sizes.Te Metric.
Graduation:0.1mmFace Dial: 57mmReading: 0-100Travel: 1mmTotal Travel: 3mmTe Imperial.
Graduation:0.0005"Face Dial: 2 3/16"Reading: 0-25-0Travel: 0.050"Total Travel: 0.25"

牛津撥號指示儀表五九毫米孔（2 3 / 16“）表盤直徑
適用于快速，準確測量尺寸，同心度，，錐度，鉆孔等在一個范圍廣泛。車間和檢驗使用。型號都有一個固定的，一個個動人的鐵砧和自我調節的中心鞋。一個“基準點”可以通過使用一個已知的直徑或千分尺設置環。“”的旋轉表圈，使之與指標“”規范這一基準點。要檢查孔是在容許范圍內，限制手可根據需要確定。砧裝有彈簧進軍孔。為了地讀計干平行于孔的軸線。這可以通過檢查“搖擺”的規來回，直到小的直徑被發現。型號都有跨多變砧，涵蓋了孔sizes.Te度量范圍。
畢業：0.1mmFace表盤：57mmReading：0 - 100Travel：1mmTotal旅游：3mmTe。
畢業：0.0005“面子表盤：2 3 / 16”閱讀：0 - 25 - 0Travel：0.050“總行程：0.25”